Simultaneous Measurement and Generation Rugged Construction for on-site use Quick Connect Terminals
Designed with a close collaboration with industrials, C50 integrates all the necessary functions for adjustment and maintenance of process.
Its ergonomic design and its embedded software allow C50 to be a high performance calibrator and very easy to use. IP 54, full protected by an anti-shock sheath, with "easy-connection®" terminals integrated, a very contrasted backlight display, it will be comfortable to use in all conditions.
Its elastomer keypad protects it from dirty and grease marks, the keys allow to use C50 with gloves. It has 10 working configurations recorded by user or user group, to always find the good configuration for designed and repetitive jobs.
FILE MENU: User can save up to 10 full configurations of the instruments and recall them as desired.
Configurations can be saved and recalled in function of user and of use. Configurations include all programming done on instrument, as the range.
LANGUAGE SETTING: P32 has 5 user selectable languages: English, French, German, Italian and Spanish.
CONTRAST ADJUSTMENT: Screen’s contrast can be adjusted as desired to fit with measurement environment.
SCREEN BACKLIGHTING: Time of backlighting can be programmed to save battery.
BATTERY LIFE: C50 Battery Life is 8 hours in the worst condition of use.
SCALING: In measurement and simulation, scaling allows process signals to be displayed in % of FS or in all other unit.
This function also allows sensors to be corrected after a calibration.
RELATIVE MEASUREMENT:
- Programming of a reference value different from the one of the instrument (NUL function).
- Subtracting of constant value by measuring or programming it from a measured value (TARE function).
SQUARE ROOT: In current measurement and simulation, this function takes into account a quadratic signal coming from transmitter of type (delta)P.
STATISTICAL FUNCTIONS: Average, Minimum, Maximum and also number of measurements done are always displayed.
Reset key allows values to be updated.
SIMULATION MENU: Simulation value is set by entering value on keypad or by changing the appropriate digit with the cursor.
RAMPS GENERATION: Starting, ending and length time values of simple or cyclic ramps can be set to do simulation.
Number of ramps can also be adjusted in case of cyclic ramps for any signals.
STEPS SIMULATION: 2 modes are proposed.
- Program mode: Starting value, number of steps and the duration of step.
- Manual mode: User has approximately one hundred preset values.
In current simulation, user will have some additional preset values in function of range and according to 0%, 25%, 50%, 75% and 100% from selected gauge.
Choice is done between gauges:
- 0-20mA: linear or quadratic
- 4-20mA: linear or quadratic
SYNTHESIZER: With 100 values manually set, the C50 allows curve generation to be remade. 100 user settable values allow complex curves to be generated
TRANSMITTER FUNCTION: C50 is able to be used as a transmitter.
Measurement input is copied on the output with scaling.