The Triple Display 196 is an innovative new concept in DMM design. The unique display enables you to view more than one event at a time. This eliminates the hassle of switching back and forth to review minimum, maximum or preset comparative values. The meter is also easy to use and built to last.
The DMM 196 is a hand-held autoranging DMM. The backlit LCD can display three readings at one time. In addition to basic function of AC/DC V, AC/DC A, Ohm, Diode test, continuity, Capacitance, Frequency, there is the adaptor function. The DMM 196 also has RS232 output and software for recording information into a PC.
The TPI 196 digital multimeter (also known as a multitester) is an average-sensing, auto- and manual-ranging meter that measures current, voltage, and resistance, and performs continuity and diode tests in electrical applications. An audible continuity sensor confirms a circuit conducts electricity, and a diode test detects proper functioning of a circuit's diodes. Separate 10 amp and 500 microamp fuses protect the meter from damage.
The meter provides statistical information such as minimum, maximum, compare, and relative mode. The relative mode stores a reading in memory to use as a zero point for subsequent readings so that multiple readings can be compared as a percentage of the stored reading, and is used for component checking. Compare mode compares the measured values with a stored value, and is used for component matching.
Temperatures can be measured using a K-type thermocouple (not included). The data hold feature holds up to two readings on the display for recording. Auto power-off turns the meter off after 30 minutes of non-use to preserve battery life. The RS-232 output exports data to a computer while measurements are being taken (requires cable and software, not included). A molded rubber boot protects the meter against damage from falls, impacts, and abrasion, and a tilt stand provides viewing for one-handed operation.