| Autonics ADS-A Series General Specifications |
| Cover color |
Silver |
| Power supply |
24-240VAC ±10% 50/60Hz, 24-240VDC ±10% (Ripple P-P: Max. 10%) |
12-24VAC ±10% 50/60Hz, 12-24VDC ±10% (Ripple P-P: Max. 10%) |
| Power consumption |
Max. 4VA (at 240VAC) |
Max. 2VA (at 24VAC) |
| Control output |
Contact type |
1a |
| Contact capacity*1 |
50VDC 0.1A (Resistive load) |
| Relay life cycle |
Mechanical: Min. 20,000,000 times, Electrical: Min. 50,000 times |
| Mounting height |
2.0m to 2.7m (max. sensing distance: 3m) |
| Sensing method |
Infrared reflection method |
| Sensing area |
9 Point |
| Output holding time |
Time delay approx. 0.5sec. |
| Holding time of stationary sensing |
Selectable 2sec., 7sec., 15sec. (selectable by holding time setting switch) |
| Interference prevention |
H, L (selectable by interference prevention switch) |
| Front sensing area |
7.5°, 14.5°, 21.5°, 28.5°: 4 steps variable (adjusting by angle adjuster) |
| Adjustable sensing area |
(1, 2, 3 Area), (7, 8, 9 Area) Eliminate each by each : Adjusting with eliminating right/left sensing area lever |
| Light source |
Infrared emitting diode (modulated) |
| Indicator |
Operation indicator: Orange, Green, Red (Refer to C-8 for the display status in operation) |
| Connection method |
Connector wire connection |
| Insulation resistance |
Min. 20MΩ (at 500VDC megger) |
| Noise resistance |
±2,000V the square wave noise (pulse width:1μ) by the noise simulator |
| Dielectric strength |
1,000VAC 50/60Hz for 1 minute |
| Vibration |
1.5mm amplitude at frequency of 10 to 55Hz in each X, Y, Z direction for 2 hours |
| Shock |
100m/s2 (approx. 10G) in each X, Y, Z direction for 3 times |
| Environment |
Ambient illumination |
Sunlight: Max. 3,000lx,Incandescent lamp: Max. 3,000lx (Receiver illumination) |
| Ambient temperature |
-20? to 50°C, storage: -20 to 70°C |
| Ambient humidity |
35 to 85%RH, storage: 35 to 85%RH |
| Accessory |
Cable: 2.5m, Mounting screw: 2EA, Mounting template |
| Protection structure |
IP50 (IEC standard) |
| Material |
Case: ABS, Lens: Acryl, Lens cover: Acryl |
| Unit weight |
Approx. 320g |
*1: Do not use Load which is beyond the rated capacity of contact point of Relay.
It can cause bad insulation, contact fusion, bad contact, relay breakdown, and fire etc.
*The temperature or humidity mentioned in Environment indicates a non freezing or condensation environment. |