C1000 (Open Head) Optical Chopper
Introducing the C1000 optical chopper which offers programmability to display the frequency status of various slot count blades, both internally and externally.
Programmable Digital Optical Chopper, Open Head with 3/30 Slot Blade for 4Hz to 5000Hz Operation. Ships with 10 Ft. Coiled Cable for Communications Between Head and Controller, USB Cable for External Communications, 15 VDC, Power Supply with International Mains and Retractable Stylus
Optical Choppers are equipped with a bi-directional RS-232 port that permits the user to set the desired chopping rate to a resolution of .001 Hz and to read the status of the instrument.
They are designed with a phase-locked-loop control system, allowing the chopping rate to also be synchronized to a user-supplied external clock ranging from 4 Hz to 5 KHz. The controller is then used to measure and display the frequency of the external clock.
The chopper heads are attached to the controller by means of a 10-foot coiled cord. The precision-etched blade is fully enclosed for protection from inadvertent damage with the closed chopper head.
The C995 Optical Chopper is equipped with a bi-directional RS-232 port that permits the user to set the desired chopping rate to a resolution of .001 Hz and to read the status of the instrument.
The C995 is designed with a phase-locked-loop control system, allowing the chopping rate to also be synchronized to a user-supplied external clock ranging from 4 Hz to 5 KHz. The controller is then used to measure and display the frequency of the external clock.
The 995 optical chopping head is attached to the controller by means of a 10-foot coiled cord. The precision-etched blade is fully enclosed for protection from inadvertent damage. An optional exposed or open-head version is also available.
There are two apertures on the chopper head and two sections on the blade for the high and low-frequency ranges. The aperture diameter is 15 mm with a slot width of 4.5 mm for the 30-slot section and 30 mm for 3 slot section. The small 4.75-inch square outline and a two-inch maximum depth of the chopper head permit easy integration into compact optical setups. Dual #8-32 mounting holes permit the apertures to be placed at a height as low as 0.75 inches above an optical bench, or with the included 1/2 inch rod and stand, as high as 13 inches above the mounting surface.
The standard units are supplied with a 3/30 blade offering the 4 Hz to 5000 Hz operation. Also available are the 1 slot blade for operation at a rate of 1.3333 Hz to 166.66 Hz and the 2/10 slot blade for operation at rates of 2.6666 Hz to 333.33 Hz when set to low and when set at the high rate, 13.333 Hz to 1666.6 Hz.