Current clamps are ideal for when you need to measure currents without breaking the circuit.

This option combines the TA018 20A / 60 A and TA234 30 A clamps in one bundle, along with a protective storage tray.

Pico TA018 20A / 60A DC (low amps) current clamp

The TA018 current clamp is ideal for use with PicoScope automotive oscilloscopes for measuring currents between 10 mA and 60 A. This enables the PicoScope to display current waveforms for fuel injectors and fuel pumps.

The current clamp has two calibration settings, set by a slider switch on the handle of the probe.

1. 1 mV/10 mA (100 mV = 1 A) - use this for testing currents up to 20 A.
2. 1 mV/100 mA (10 mV = 1 A) - use this for testing current up to 60 A.

In use there is no need to break into the circuit or disturb the isolation as the opening jaws simply clamp around the current carrying conductor. No electrical contact is required.

These current clamps have been designed for use with PicoScope oscilloscopes and feature additional screening to reduce noise pickup. The Pico TA018 current clamp can either be purchased as an accessory within one of our popular diagnostic kits or individually under the packing code PP264.

Pico TA234 30A (low amps) current clamp

The TA234 probe is a 30 A current clamp. The extended measuring jaws allow measurement in a confined space. When measuring DC, a simple thumbwheel on the probe allows zero adjustment.

This current clamp is ideally suited for use with PicoScope oscilloscopes and features additional screening to reduce noise pickup.

With a 20 mm extended jaw the TA234 low amps current clamp is ideal for parasitic drain measurements without the need for battery cable disconnection.