Output Channels |
AFG310 | 1. |
AFG320 | 2. |
Standard Waveforms | Sine, Square, Triangle, Ramp, Pulse, DC and Noise. |
Arbitrary Waveforms |
Waveform Length | 10 to 16384 points. |
Vertical Resolution | 12-Bit. |
Sample Rate | 16 MS/s. |
Nonvolatile Memory | Four 16 k waveforms. |
Output Frequency |
Sine, Square | 0.01 Hz to 16 MHz. |
Triangle, Ramp, Pulse | 0.01 Hz to 100 kHz. |
Noise (Gaussian) | Maximum 8 MHz bandwidth. |
Arbitrary Waveform |
Repetition Rate | 0.01 Hz to 1.6 MHz. |
Resolution | 7 digits. |
Accuracy | 50 ppm. |
Output Characteristics |
Amplitude (into 50 Ohm) | 50 mVp-p to 10 Vp-p. |
Accuracy | ±(1% of setting + 5 mV) at 1 kHz, no offset. |
Flatness (at 1 V amplitude relative to 1 kHz) | < 100 kHz: ±1%. 100 kHz to 1 MHz: ±1.5%. 1 MHz to 16 MHz: ±3%. |
Offset (into 50 Ohm) | 505 mVp-p to 10 Vp-p amplitude: peak amplitude + offset is limited to +5 V or -5 V. |
50 mVp-p to 500 mVp-p amplitude | -0.75 V to +0.75 V. |
Accuracy | ±(1% of setting +5 mV). |
Resolution | 5 mV. |
Output Impedance | 50 Ohm. |
Isolation | 42 V peak maximum relative to earth ground. |
Phase |
Range | ±360°. |
Resolution | 1°. |
Sine Wave Spectral Purity |
Harmonic Distortion |
DC to 20 kHz | -70 dBc. |
20 kHz to 100 kHz | -60 dBc. |
100 kHz to 1 MHz | -45 dBc. |
1 MHz to 16 MHz | -35 dBc. |
Total Harmonic Distortion |
20 kHz | 0.05% at 1 V amplitude. |
Signal Characteristics |
Square |
Rise/Fall Time | <20 ns. |
Overshoot | < 2%. |
Pulse |
Rise/Fall Time | < 100 ns. |
Duty Cycle | 1% to 99% of period. |
Triangle, Ramp, Pulse, Arbitrary |
Jitter | 2 ns at 100 kHz. |
Modulation |
AM |
Source | External only. |
Carrier | Up to 16 MHz. |
Modulation | Any internal waveform plus Arb. |
Frequency | DC to 200 kHz. |
Depth |
1 V | 100%. |
0 V | 50%. |
-1 V | 0%. |
2 Vp-p for 100% modulation. |
FM |
Source | Internal only. |
Modulation | Sine, Square, Triangle, Arb. |
Frequency | 0.01 Hz to 10 kHz. |
Deviation | 0.01 Hz to 8 MHz. |
FSK (frequency shift keying) |
Source | Internal only. |
Mode | Trigger, Burst. |
Frequency range | 0.01 Hz to 16 MHz. |
Key rate | 0.01 Hz to 50 kHz. |
Number of keys | 2. |
Frequency Sweep - |
Type | Linear or logarithmic. |
Direction | Up or down. |
Start/Stop Frequency | 0.01 Hz to 16 MHz. |
Time | 1 ms to 100 s. |
Mode | Continuous, Trigger, Burst. |
Operating Mode - |
Continuous | The selected waveform is output continuously. |
Triggered | One period of the selected waveform is output each time a trigger occurs. |
Trigger source | Manual, External. |
Burst | The selected waveform is output with a specified number of cycles each time a trigger occurs. |
Carrier Frequency | Up to 1 MHz. |
Count | 1 to 60,000 cycles/burst (100 s maximum except sine wave or square wave) or infinite. |
Start phase | -360 to +360°. |
Trigger source | Manual, External. |
Inputs/Outputs - |
Front Panel |
Main output | Ch 1, Ch 2 (AFG320 only). |
External Trigger (Burst) input |
TTL input. |
Pulse Width | 1 µs minimum. |
10 kilohm input impedance. |
Rear Panel |
Sync Output | TTL level. |
External AM modulation | 2 Vp-p = 100% modulation. 10 kilohm input impedance.
|
GPIB Interface (IEEE 488.2). |
Memory |
Type | Nonvolatile. |
Setup Storage | 20. |
Arbitrary Waveform Storage | 4. |
Environmental, EMC, Safety |
Temperature Range - |
Operating | 0° to +50° C. |
Nonoperating | -20° to +60° C. |
Humidity-Operating | At or below +40° C: 0 to 95%. +40° to +50° C: 0 to 75%. |
Random Vibration |
Operating | 0.31 GRMS from 5 to 500 Hz, 10 minutes. |
Nonoperating | 2.46 GRMS from 5 to 500 Hz, 10 minutes. |
Shock | Nonoperating: 294 m/s2 (30 G), half-sine, 11 ms duration. |
EMC Compliance | Meets intent of Directive 89/396/EEC for Electromagnetic Compatibility. |
Australian AN/NZS 2064.1/2. |
Safety | UL1244, CSA231, EN61010-1, IEC61010-1. |
Power |
Line Voltage | 90 to 132 V AC, 180 to 250 V AC. |
Line Frequency |
90 to 250 V | 48 to 63 Hz. |
90 to 127 V | 48 to 440 Hz. |