This ESD coat is an effective static shield. The medium-weight IVX‐400 fabric makes this style one of our most popular garments. The surface resistivity of the fabric is 1X105 and the sleeve‐to‐sleeve resistance of the garment is guaranteed to stay below 3.5X107 for 100 washes or 2 years. This traditional‐style coat comes with the “Reaching Hand Symbol” next to the breast pocket indicating that this garment is a tool for the prevention of static discharge.

• Traditional lab coat
• Hip-Length
• Available in Royal Blue
• Lapel collar
• 3 Pockets
• X-Small thru 4X-Large size range
• IVX-400 medium-weight fabric
• ANSI/ESD STM 2.1-2013, Category 3

• Royal Blue
• Meets normal FR requirements for polyester fabrics.
• Fabric will not crock or bleed off onto other surfaces.
• Fabric content 93% texturized polyester and 7% Shakespeare Conductive Fibers
• Carbon-suffused monofilament nylon is Shakespeare Resistat® fiber is conductive at 104 and is non-flaking and non-sloughing.
• Surface resistivity of fabric is 105 ohms per square
• Static decay rate per 101°C method 5000 volts to 500 in less than 0.1 seconds.

All Tech Wear garments made of IVX-400fabric will meet the requirements of the National ESD Association’s ANSI/ESD STM 2.1-2013, Category 3, “Garment used as primary grounding path for personnel” and/or “Grounded through a single wire constant monitor system”, and will maintain these performance characteristics for a minimum of 100 washes or 2 years, whichever comes first.

Cool or warm water wash with any commercially-available liquid detergent, tumble dry on low heat or hang dry. DO NOT USE BLEACH OR FABRIC SOFTENERS. The carbon-suffused mono-filament nylon is sensitive to heat and should not be exposed to drying heat in excess of 120°F. Wash at 90°F (Maximum), and tumble dry at low heat or hang dry. This medium-weight fabric will dry very quickly, and we recommend hang-drying for maximum life.

Notes:

• Due to fabric elasticity, all measurements are within +/- inch.
• Length is measured from the center back of the neck to the finished hem.
• Finished sleeve is measured from the center back of the neck to the bottom of the sleeve hem. or bleach. Hang dry or tumble dry at the lowest temperature setting. The garment will dry very quickly. Do not allow garment