The ESD grid-knit cuffs form a contact patch around both of the wearer's wrists. The garment and wearer are then both grounded by attaching a ground cord to the 4mm stainless steel snaps on either hip pocket. (Ground cord sold separately.) All Tech Wear garments meet the federal standard for FR (flammability retarding) requirements for polyester fabrics, except sleepwear. The glass transition rate (i.e. melting temperature) is 450 degrees F and the flash point (combusting temperature) is 720 degrees F. Groundable with ESD Grid-Knit Cuffs.

• Hallmark jacket with ESD cuffs
• Available in Royal Blue
• Long sleeve, Front snap closure
• V-neck collar, Three patch pockets
• Hip-Length
• Small thru 5X-Large size range
• IVX-400 Fabric
• Male 4mm snaps at the hip for the standard ground cord (not included)
• ANSI/ESD STM2.1-Cat. 3
• 100 wash guaranteed

• Royal Blue
• Meets normal FR requirements for polyester fabrics.
• Fabric will not crock or bleed off onto other surfaces.
• Fabric content 93% texturized polyester and 7% Shakespeare Conductive Fibers
• Carbon-suffused monofilament nylon is Shakespeare Resistat® fiber is conductive at 104 and is non-flaking and non-sloughing.
• Surface resistivity of fabric is 105 ohms per square
• Static decay rate per 101°C method 5000 volts to 500 in less than 0.1 seconds

Static Control Performance

All Tech Wear garments made of IVX-400fabric will meet the requirements of the National ESD Association’s ANSI/ESD STM 2.1-2013, Category 3, “Garment used as primary grounding path for personnel” and/or “Grounded through a single wire constant monitor system”, and will maintain these performance characteristics for a minimum of 100 washes or 2 years, whichever comes first.

Laundering Instructions

Cool or warm water wash with any commercially-available liquid detergent, tumble dry on low heat or hang dry. DO NOT USE BLEACH OR FABRIC SOFTENERS. The carbon-suffused mono-filament nylon is sensitive to heat and should not be exposed to drying heat in excess of 120°F. Wash at 90°F (Maximum), and tumble dry at low heat or hang dry. This medium weight fabric will dry very quickly, and we recommend hang-drying for maximum life.

Notes:

• Due to fabric elasticity, all measurements are within +/- inch.
• Length is measured from center back of neck to finished hem.
• Finished sleeve is measured from center back of neck to bottom of sleeve hem.