Starrett 568A - V-Block and Clamp (1 of each)
V-Blocks come in a variety of styles to suit the numerous requirements of machinists. They are intended for general shop use and layout work, as well as for holding stock in place during light-duty milling, drilling, and grinding operations. All clamp screws have a hole to help secure the workpiece.
Starrett 568A V-Blocks and Clamps
- Hardened steel, precision ground parallel and square
- V-grooves are ground central and parallel to the sides and base – perfect alignment in matched pairs
- Clamps have screw holes at 45 and 90 degrees to hold either square or round work
- Stepped groove construction permits high or low clamp mounting for small or large work
- Clamps do not project over the width of the block, permitting it to be used on the base, ends or sides
- 3/8-16 tapped holes permit mounting blocks on faceplates or angle irons
- Each block is 2-1/2in long x 3in wide x 2in high (63 x 75 x 50mm)