Product Model
![]()
AC/TRMS Current
Simpson's Mini DC Current Indicators provide high quality, accuracy, and reliability in a compact 12mm deep case. M135 has a 3-1/2 digit, 0.5” LCD display and is available with a negative image, bright red backlight option. Mini M135s feature user-selectable decimal point and display hold.
AC/TRMS Voltage
The Falcon Series digital indicators are premium quality 1/8 DIN meters for industrial applications. All Falcon units feature jumper selectable decimal point (internal and on the connector for remote decimal point) and display scaling, providing wide application flexibility. In addition, signal input ranges are easy to change with jumpers on the main board. The Falcon has a 0.56" bright red LED display for high visibility.
Frequency
The Falcon Series digital indicators are premium quality 1/8 DIN meters for industrial applications. Two input ranges are available, 20-199.9Hz or 20-1999Hz, with choice of RMS or Square Wave. The Falcon has a 0.56" bright red LED display for high visibility. Compactly designed for applications requiring minimal rear panel depth, the Falcon fits a standard 1/8 DIN panel cutout (92mm x 45mm) and requires less than 3" behind the panel. A screw terminal connector is a standard feature for easy wiring of the power supply and signal input connections.
Installation and Panel Cut Out - Simpson F35
![Installation_and_Panel_Cutout]()
Mounting Requirements
The Falcon series 1/8 DIN indicators require a panel cutout of 1.77"(45mm) high by 3.62" (91.9mm) wide. To install the Falcon into a panel cutout, remove the clips from the side of the meter. Slide the meter through your panel cutout, then slide the mounting clips back on the meter. Press evenly to ensure a proper fit.
Engineering Label Placement
If replacement of the engineering unit label is required, place the tip of a ball-point pen into the small hole at the base of the engineering label in the bezel. Slide the label up until it pops out. Grasp and remove. Slide the new label half the distance in, then use the ball-point pen to slide it down into