• Solid fiberboard construction with a buried conductive layer
• Includes two installed 3/8 inch stud snaps - socket snaps available
• Resists damage by hot soldering irons, solder, or flux
• RTT of top and bottom layers: 1 x 10⁶ to < 1 x 10⁹ ohms - meets worksurface recommendation of ANSI/ESD S4.1
• Thickness: 0.060 inch (1.5mm)

The Protektive Pak 39800 is a pro mat female snap with a size of 23-1/2" x 59-1/2" x 1/16". The most important functional consideration for worksurfaces is the RTG resistance from the top of the surface to the groundable point. ANSI/ESD S20.20 Table 1 recommends a requirement of less than 1 X 10⁹ ohms. If Charged Device Model damage is a concern then setting a lower resistance limit should be considered. Typically, 1 x 10⁶. Durability factors that should be considered are hardness, abrasion resistance, tear resistance, etc. Worksurfaces may require special heat-resistant materials. Light reflection may be an important ergonomic consideration.