• 107: 0-10 Microsiemens
• 4A: 4-20mA Self-Powered Isolated Output Module
• PC: Power Cord 115VAC
• 3 1⁄2in digit LC Display
• Automatic temperature compensation to 25°C

The unique circuitry of the 750 Series II Conductivity Monitor/controllers guarantees accurate and reliable measurements. Drift-free performance is assured by “field-proven” electronics, including automatic DC offset compensation and highly accurate drive voltage.

Since temperature compensation is at the “heart” of accurate water measurement, all Myron L monitors/controllers feature a highly refined and precise TC circuit. This feature perfectly matches the water temperature coefficient as it changes. All models corrected to 25°C. Uncompensated models are available to conform with USP 25.

A push-to-test button makes setpoint checks easy, while the internal alarm set discourages unauthorized adjustments.

Standard on all controller models is a heavy-duty 10-amp output relay, operating on either increasing or decreasing readings. Bright green/red LEDs indicate above or below setpoint readings.

All 750 Series II models feature an IP65/NEMA 4X water-resistant and corrosion-proof rated enclosure. Compact in size at 152 x 122 mm / 6 x 4.8 in., they are suitable for panel, bench, or surface mounting. 

• Conductivity/TDS-Digital Monitor/Controller
• 107: 0-10 Microsiemens
• 4A: 4-20mA Self-Powered Isolated Output Module
• PC: Power Cord 115VAC
• 3 1⁄2in digit LC-Display
• Automatic temperature compensation to 25°C
• Isolated 0-10 VDC Recorder Output standard
• IP65/NEMA 4X water-resistant and corrosion-proof enclosure (digital only)
• Single setpoint/alarm
• Adjustable setpoint hysteresis
• Solid State 24 VDC Output
• 10-amp relay operates on the choice of increasing or decreasing reading
• LEDs show “above/below” Alarm/control status
• Push-to-test setpoint check
• Internal setpoint discourages unauthorized adjustment
• Selectable 115/230 VAC
• CE Approved
• Unique, easily installed sensor