Hydraulic Punch Driver ×

Punches 10 times faster than wrench method Will also drive 751 cable cutter head Fast, easy and simple to operate Can be used with most standard round, Slug-Buster and Slug-Splitter punches (not 1/2", 9/16", 5/8").

Driver, hand pump, Slug-Buster punches dies and draw studs for 1/2" through 2" conduit, adapter, spacers, Kwik Stepper Step Bit and plastic case.

The Greenlee hydraulic punch driver sets combine the 746 Hydraulic Ram with the 767 Hand Pump or the 1725 Foot Pump. These hydraulic driver sets are intended to be used with either standard or Slug-Buster punches and dies to punch holes through plastic, fiberglass, aluminum, and steel. Greenlee Slug-Splitter punches, dies, and draw studs are capable of punching through all of these materials and stainless steel.

Round punches are available for punching holes from 12.7 mm through 144 mm (1/2" through 5-5/8") in diameter, including 1/2" through 5" conduit and pipe sizes. Other shapes are available — square, special square, rectangular, “D”, double “D”, electronic connec- tor, oiltight with notches, and key.

The maximum thickness of material that the punch can penetrate depends on the size and shape of the punch. Refer to the instruction manual supplied with the punch for individual punch capacities.

Setup and Operation Instructions

1. Remove the dust caps from the couplers; attach the hose to the ram and to the pump. Thread the dust caps together.
   Note: Hand-tighten the couplers completely until all threads are engaged. Do not use tools.
2. Select the punch, die, and draw stud that will make the appropriate size hole.
3. Determine and mark the exact location for the hole. Using a drill bit that is slightly larger than the draw stud, drill a hole. This is the pilot hole.
4. Thread the 3/4" piston shaft (B) completely into the ram (A). Refer to the illustration.
   Note: For a punch and die with a 3/8" center hole, thread the 3/8" adapter draw stud (F) into the end of the piston shaft. For a punch and die with a 1-1/8" center hole, thread the screw sleeve (E) onto the piston shaft.
5. Install spacers as necessary. Refer to the illustra- tions on this page.
6. Slide the die over the draw stud with the open end of the die facing away from the ram.
7. Insert the draw stud through the pilot hole.
8. Thread the punch onto the draw stud with the cutting surfaces of the punch facing the material. Tighten the punch by hand until the spacers, die, material, and punch are snug.
   Note: All of the punch threads must be engaged by the draw stud threads. If any of the punch threads are not engaged, dis-assemble the setup, remove one of the spacers, and reassemble the setup.
9. Activate the pump. For specific instructions, refer to the operating manual supplied with the pump.
   Note: Support the weight of the ram when operat- ing the pump. This will prevent the ram from falling when the punch is complete.
10. Release the pressure at the pump.

 

Setup and Operation Instructions

×

Product Overview Powerful 11-ton hydraulic ram that punches 10 times faster than wrench method. Slug Buster Punches and Dies for 1/2" through 2", and 2-1/2" through 4" standard conduit size punches and dies, and draw studs Compact design with a rugged carrying case for field use on construction sites and maintenance jobs.

Hydraulic Driver Punch Kit ×