Frequency Characteristics:
Waveforms: Sine, Square, Triangle, ± Pulse, ± Ramp
Range: 0.2Hz to 20MHz in 8 ranges
Resolution: 5 digits
Frequency stability: 0.1%
Tuning Range: Coarse 10:1, Fine 1/16% of Coarse Setting speed
Variable Duty Cycle: 15:85:15 Continuously Variable
Operating Modes: Normal, Sweep, VCG, AM, FM, Burst |
Output Characteristics:
Impedance: 50 ohm ±10%
Level: 20v p-p Open Circuit, 10v p-p into 50 ohm
Amplitude: variable 20dB range typical
DC Offset: Preset ±0.1v Variable ±10v open circuit, ±5v into 50 ohms
Auto + negative peak of waveform 0v ± 0.1v
Auto - positive peak of waveform 0v ± 0.1v |
Waveforms:
Sine Wave:
Distortion: 1% typical at 1kHz
Flatness: ±5% .45dB 10Hz to 10MHz, ±10% (1.0dB) 10 MHz to 20MHz
Square Wave:
Symmetry: 0.1Hz to 100kHz <2%
Rise Time: 20ns
Square Wave divide by 10 or 100:
Auxiliary square wave outputs at 1/10th
and 1/100th of the main frequency. -TTL
levels
Triangle Wave:
Linearity: >98% to 100kHz |
External Input:
Frequency range: 5Hz to 40 MHz
Resolution: 0.1Hz, 1Hz, 10Hz 100Hz 1kHz, automatically switched depending on input frequency
Sensitivity: <25mV RMS
Impedance: 1M ohm/ 100pF |
TTL Output:
Level: 0.8v 2.4v
Rise Time: <20nS
Duty Cycle: 50% typ. |
CMOS Output:
Level: 0-4v to 0-14v Continuously variable
Rise Time: <120ns
Operation unspecified at frequencies >2MHz |
VCG (Voltage Controlled Generator Input):
Input Voltage: 0-10v ±1v, 0-10v causes a 100:1 frequency change
Impedance: 10k ±5% |
Frequency Counter:
Accuracy: ±10ppm ±1 count at 23š C ±5š C
Display: 5 digit LED |
Power Source:
110/230v ac 50/60Hz |
Communication Port:
RS-232 |
Sweep Operation:
Mode: Linear or Log
Width: 100:1 continuously variable
Rate: 20ms to 30s continuously variable
Sweep output: 0-2v
Start/stop frequencies adjustable |
Amplitude Modulation Characteristics:
Source: Internal or External
Modulation Depth: 0-100%
Internal Modulation: 1 kHz
External Modulation: DC to 500kHz
External Sensitivity: <10v for 100% modulation |
Frequency Modulation Characteristics:
Source: Internal or External
Deviation: 0-5%
Internal Modulation: 1 kHz
External Modulation: DC to 500kHz
External Sensitivity: <10v for 5% deviation |
Burst Characteristics:
Source: Internal or External
Burst Width: Continuously Variable from 5% to 90% of burst repetition rate
Repetition Rate: 0.5Hz internal, DC to 500kHz external
External Level: TTL levels
Burst Frequency: Same as Main Generator frequency
Burst is always an integral number of cycles, starting and finishing at zero crossing |