Fluke Y8846D Dual Rack Mount Kit

• 1 Rack mount tray
• 2 #8-32 x 1/2" panhead Philips screws
• Enables mounting two meters side-by-side in a standard 19-inch rack

This rack kit is designed to hold Fluke's precision multimeters in a fixed location.

Enables mounting two meters side-by-side in a standard 19" rack. (2) Small filler plate. (1) Dual center mount. (4) #10-32 rack nuts. (1) Rack mount tray. (2) #8-32 x 1/2" panhead Philips screws. (2) #6-32 x 1/4" panhead Philips screws. (4) #10-32 x 3/4" Philips rack screws. (2) #6-32 x 1/2" panhead Philips screws.

Installing a Dual Rack Mount Kit

To install the Y8846D Rack Mount Kit, first follow the steps 2, 3, and 4 listed under “Installing a Single Rack Mount Kit” earlier in this document. Next, perform the following steps to install the second Meter. 

1. Insert a second #6-32 x ½" flathead screw through the hole in the back of the tray into the back of the second Meter.
2. With the tray flat on a desk with the rack screw ears toward you, place the second Meter so the right side of the front frame is against the right wall of the tray.
3. Insert the Dual Center Mount between the two Meters, keeping the holes on the bottom
4. Insert two #6-32 x ¼" screws through the bottom of the tray and into the Dual Center Mount.
5. Install the assembled rack mount kit into a rack using the two 1" wide small filler plates and four #10-32 x ¾" Phillips rack screws.
6. Complete the installation by installing the Meter’s power cord and other IO accessories through the rear of the rack.