• Temperature: (-200 to +260) °C, Pt1000/3850 ppm, measuring current: ca 0.5 mA in ca 60 ms long pulses
• Voltage: (0-10) V DC, input resistance: approx. 130 kO
• High quality, accurate and stable sensors
• Built-in printer

Datalogger is designed to record 2 voltage inputs and 2 temperature inputs Pt1000. The recording is performed in a non-volatile electronic memory. The data can be transferred to a PC via USB-C. In case of exceeded set limits alarms are indicated by LED, LCD and acoustically by built-in beeper.

Recorder includes Traceable calibration certificate with declared metrological traceability of etalons is based on requirements of EN ISO/IEC 17025 standard.

Connection Mode: For the procedure for connecting wires to the connecting block refer to Annex 4.

This model can measure up to two temperature values, which are sensed by outdoor Pt1000/0 series probes. In addition, it has two voltage inputs for monitoring voltage signal changes. Input signals are connected to a connecting block. The response to a temperature jump depends on the probe design. As a rule, this device is a few times faster than the inner-sensor model. The maximum length of the temperature probe should not exceed 15 m; the maximum length of the voltage input cable should not exceed 30 m. It is recommended to use shielded cables. The device’s ingress protection is IP 20. Due to low ingress protection, the device is not suitable for use in dusty rooms or rooms exposed to water ingress. The battery in the device cannot be charged.