• Dual-channel logger with pulse and binary input
• Data logger is designed for the record of pulses and two-state events.
• Values are stored in non-volatile electronic memory.
• Data transfer to the personal computer for further analysis is performed via USB, RS232, GSM, or Ethernet interface by means of a proper communication adapter

Data logger is designed for record of temperature and humidity. Values are stored in non-volatile electronic memory. Data transfer to the personal computer for further analysis is performed via USB, RS232, GSM, or Ethernet interface by means of a proper communication adapter.

Main Applications of Pulse Data Logger:

• Record of pulses from water meter, gas meter, electrometer, flow meter, revolution counter
• Time event record from binary signal (e.g. door opening/closing .. )
• Production monitoring
• Long term field measurement

• Advantages of Data Logger
• Counter reading is possible to display in real value, range of the LCD display is 19999, after exceeding of displayable value only lowest places are displayed
• Two modes are enabled: after counting of maximum value counter stops or overflows and counts again, counter reset enabled from the PC
• in the record is possible to indicate counter state or counter state increment between logging intervals
• Record from binary input contains date and time (resolution of 1 s) when change of input logic level appeared and its logic state
• Record from binary input can be disabled
• It is possible from the PC to assign both logic states of binary input a description, which is displayed on the record – on the LCD logic states are Always displayed as ON ( contact closed) and OFF (contact opened)
• Variability of connection to the computer - USB, RS232, Ethernet, GSM modem
• Permanent connection to the PC enabled, data is possible to download even during logging
• Dual-level alarm is enabled for counting input, an alarm is indicated by blinking of the value on the LCD display
• Low power consumption from battery, easy replacement of the battery
• Logging start/stop is enabled: at a certain time and date programmed from a computer, by external signal connected to binary input or by a delivered magnet
• Also, special logging mode is enabled, when logging runs only if counter value is out of adjusted alarm limits
• Input pulse signal is recalculated and displayed in real measured physical units by means of the PC software
• Extremely low consumption from the battery, indication of remaining battery life, easy battery replacement
• Robust watertight case, easy installation, locking enabled
• Each logger is possible to describe with the text of a maximum of 32 characters
• Each channel is possible to describe with the text of a maximum of 16 characters
• Password protection is enabled to prevent unauthorized manipulation with logger