Sine: 1µHz ~ 80MHz Square: 1µHz ~ 40MHz All Other waveforms: 1µHz ~ 100kHz Frequency Stability: ?1x10-6 (22?C ?5?C) Resolution: 1µHz Accuracy: = ? 5x10-6 (22?C ?5?C) Data entry Units: s, ms, Hz, kHz, MHz Amplitude resolution: 12 bits Sample Rate: 200MSa/s Harmonic Distortion of Sine Wave*: = - 50dBc (frequency = 5MHz)= - 45dBc (frequency = 10MHz)= - 40dBc (frequency = 20MHz)= - 35dBc (frequency = 40MHz)= - 30dBc (frequency 40MHz) THD*: 0.1% (20Hz ~ 100kHz) Rise and fall time*: = 15ns * = Note: Test conditions for harmonic distortion, sine distortion, rise/fall time Output Amplitude 2Vp-p, Environmental temperature: 25?C?5?C Non volatile memory: 8 waveforms Waveform length: 8~16000 points Amplitude resolution: 10 bits Frequency range: 1µHz~100kHz Sample rate: 200MSa/s 27 build-in standard and complex waveforms: Sine, Square, Triangle, Positive Ramp, Falling Ramp, Noise, Pulse, Positive Pulse, Negative Pulse, Positive DC, Negative DC, Stair wave, Coded Pulse, Full wave rectified, Half-wave rectified, Sine transverse cut, Sine vertical cut, Sine phase modulation, Logarithmic, Exponential, Half-round, Sinx/x, Square root, Tangent, Cardiac, Earthquake, Combination Waveform Length: 4096 dots Amplitude Resolution: 10 bits Duty Cycle: 0.1% ~ 99.9% (below 10kHz)1% ~ 99% (10kHz ~ 100kHz) Rise/Fall Time: = 100ns (Duty Cycle 20%) DC range: = 10mV ? 10V (high impedance) DC Accuracy: = ?5% of setting +10mV (high impedance) Amplitude Range: Freq = 40MHz: 2mV ~ 20Vpp (open circuit) , 1mV ~ 10Vpp (50O)Freq 40MHz: 2mV ~ 4Vp-p (open circuit), 1mV ~ 2Vpp (50O) Resolution: 2µVpp (open circuit), 1µVpp (50O) Accuracy: ? 1%+0.2mV (sine wave relative to 1kHz) Stability: ?0.5 % /3 hours For amplitude: = 2Vpp ?3% (freq= 5MHz), ?10% (5MHzfreq= 40MHz) For amplitude: 2Vpp: ?5% (freq= 5MHz), ?10% (5MHzfreq= 20MHz)?20% (frequency20MHz)?1dBm (frequency40MHz) Output Impedance: 50O Output Units: Vpp, mVpp, Vrms, mVrms, dBm Offset Range (open circuit): Freq = 40MHz): ?10Vpk ac+dc (Offset = 2 x pk - pk amplitude)Freq 40MHz): ?2Vpk ac+dc (Offset = 2 x pk - pk amplitude) Offset Error: ?5% of setting +10mV (Ampl. = 2Vpp into open circuit)?5% of setting +20mV (Ampl. 2Vpp into open circuit) Carrier Waveforms: Sine or Square Modulation Source: Internal or external Internal Modulating Waveform: Sine, Square, Triangle, Rising/Falling Ramp Frequency of modulating signal: 100µHz ~ 20kHz Distortion: = 2% Modulation Depth: 1% ~ 120%, 1% ~ 80% (frequency40MHzAmpl 2Vpp into open circuit) Modulation Error: ? 5%+0.2% (100µHz frequency = 10kHz)?10%+2% (10kHz frequency = 20kHz) Max. Amplitude of ext. input signal: 3Vp-p (-1.5V~ +1.5V) Carrier Waveforms: Sine or Square Modulation Source: Internal or external Internal Modulating Waveform: Sine, Square, Triangle, Rising/Falling Ramp Frequency of modulating signal: 100µHz ~ 10kHz Deviation: Max. 50% of carrier frequency for internal FMMax 100kHz (carrier frequency= 5MHz) for externalFM, with input signal voltage 3Vp-p (-1.5V~+1.5V) Carrier Waveform: Sine or Square Control ModeI: Internal or external trigger (external: TTL level, low level F1, high level F2) FSK Rate: 0.1ms ~ 800s Carrier Waveform: Sine or Square PSK: Phase 1 (P1) and Phase 2 (P2), range: 0.0 ~ 360.0? Resolution: 0.1? PSK rate: 0.1ms ~ 800s Control Mode: Internal or external trigger (external: TTL level, low level P1, high level P2) Waveform: Sine or Square Burst Counts: 1 ~ 10000 cycles Time interval between bursts: 0.1ms ~ 800s Control Mode: Internal, single or external gated trigger Waveform: Sine or Square Sweep Time: 1ms ~ 800s (linear), 100ms ~ 800s (log) Sweep Mode: Linear or Logarithmic Start/ Stop Frequency: Same as frequency range of Sine & Square External trigger signal frequency: DC ~ 1kHz (linear) DC~10Hz (log) Control Mode: Internal or external trigger Impedance: 50O Protection: Short circuit and overload protected Frequency: 100Hz ~ 20kHz Waveform: Sine, Square, Triangle, Rising/Falling Ramp Amplitude: 5Vp-p ? 5% Output Impedance: 600O Modulation IN: 3Vpp = 100% Modulation External Input Trig/FSK/Burst: Level - TTL Frequency Measurement: 1Hz ~ 100MHz Totalize mode: 50MHz max Power Supply: 198~242V or 99~121V, Frequency: 47~ 63Hz Power Consumption: 35VA Storage Parameters: frequency, amplitude, waveform, DC offset values, modulation parameters Storage Capacity: 10 user configurable stored states Dimensions (W x H x D): 10? x 3.93? x 14.56? (255 mm x 100 mm x 370 mm) Weight: 6.6lbs (3 kg) Remote Interface: RS232 Safety designed according to: EN61010 EMC tested according to: EN55022, EN55024, EN61326, EN601000 |