| AT-2000-A AdvAnced Wire Tracer Series Specifications |
| Traces energized wires and locates breakers without interrupting power |
9 – 300 V ac/dc (S2600-A signal load generator) |
Traces non-energized wires (continuity and grounded wire) and
pinpoints shorts & ground faults. |
T2200 transmitter and 9 V battery |
| Pinpoints non-energized open wires (broken or disconnected wire). |
T2200 transmitter |
Supplied with clamp-on attachment to inject signal
without contacting a bare wire. |
Yes |
| Supplied with battery booster to strengthen signal for open tracing. |
Yes (AT-2005-A only) |
| R2000 Receiver |
■ |
■ |
| S2600-A Load Signal Generator |
■ |
■ |
| T2200 Transmitter for Open Tracing |
■ |
■ |
| A2201 Clamp-on Transmitter Accessory |
■ |
■ |
| C2901 Cord Set - 110V Plug to Banana Plugs |
■ |
■ |
| C2902 Cord Set - Alligator Clips to Banana Plugs |
■ |
■ |
| B2024 Rechargeable Battery Pack |
|
■ |
| B2025 Battery Pack Recharger |
|
■ |
| Users Manual |
■ |
■ |
| AT-2000-A Advanced Wire Tracer Series Detailed Specifications |
| Operating temperature |
0 °F to 120 °F (-18 °C to 49 °C) |
| Storage temperature |
-40 °F to 150 °F (-40 °C to 66 °C) |
| Case size |
11 x 15.5 x 4 in (39.4 x 27.9 x 10.2 cm) |
| Detectors |
Electromagnetic coil pick-up for short mode
Electrostatic plate pick-up for open mode |
| Sensitivity selection |
x1, x10, x100 course gain adjustment; 0 – 10 fine adjustment |
| Short mode performance |
Over 20 feet in air under test conditions |
| Open mode performance |
Over 12 feet in air under test conditions |
| 60 Hz Rejection |
120 bd |
| Power supply |
9 V alkaline battery |
| Display |
10 LEDs with Chroma filter lens |
| Operating voltage |
9 - 300 V ac/dc |
| Operating frequency |
32.768 KHZ |
| Duty cycle |
Transmit 2 pulses with a duration of 0.0625 seconds each, every 0.5 seconds |
| Current output – Low mode |
35 mA peak, 4 mA average |
| Current output – High mode |
70 mA peak, 6 mA average |
| Operating frequency |
32.768 kHz |
| Duty cycle |
Transmit 2 pulses with a duration of 0.0625 each every 0.5 seconds |
| Signal output |
9 V battery |
24 V battery |
| High setting |
1 A, 31 V |
3 A, 105 V |
| Medium setting |
1.8 A, 13 V |
6 A, 45 V |
| Low setting |
3.0 A, 6.5 V |
10 A, 22 V |
| Battery |
9 V alkaline
24 V jack will accept battery pack accessory (B2024 or B2025) |
| Operating frequency |
32.768 kHz as supplied by the T2200 |
| Case break down voltage |
3000 V |
| Maximum wire size |
2000 MCM or 2” diameter cable |
| Battery |
None, power is supplied by the T2200 |
| Type |
Nickel-cadmium rechargeable (20AA cells) |
| Capacity |
24 V, 600 mAh |
| Recharge time |
14 hours |
| Input |
115 V ac |
| Output |
24 V dc @ 350 mah |